diff options
Diffstat (limited to 'doc/classes/ConeTwistJoint.xml')
| -rw-r--r-- | doc/classes/ConeTwistJoint.xml | 10 |
1 files changed, 5 insertions, 5 deletions
diff --git a/doc/classes/ConeTwistJoint.xml b/doc/classes/ConeTwistJoint.xml index c268e66abd..8f2739c037 100644 --- a/doc/classes/ConeTwistJoint.xml +++ b/doc/classes/ConeTwistJoint.xml @@ -13,23 +13,23 @@ <methods> </methods> <members> - <member name="bias" type="float" setter="set_param" getter="get_param"> + <member name="bias" type="float" setter="set_param" getter="get_param" default="0.3"> The speed with which the swing or twist will take place. The higher, the faster. </member> - <member name="relaxation" type="float" setter="set_param" getter="get_param"> + <member name="relaxation" type="float" setter="set_param" getter="get_param" default="1.0"> Defines, how fast the swing- and twist-speed-difference on both sides gets synced. </member> - <member name="softness" type="float" setter="set_param" getter="get_param"> + <member name="softness" type="float" setter="set_param" getter="get_param" default="0.8"> The ease with which the joint starts to twist. If it's too low, it takes more force to start twisting the joint. </member> - <member name="swing_span" type="float" setter="_set_swing_span" getter="_get_swing_span"> + <member name="swing_span" type="float" setter="_set_swing_span" getter="_get_swing_span" default="45.0"> Swing is rotation from side to side, around the axis perpendicular to the twist axis. The swing span defines, how much rotation will not get corrected along the swing axis. Could be defined as looseness in the [ConeTwistJoint]. If below 0.05, this behavior is locked. Default value: [code]PI/4[/code]. </member> - <member name="twist_span" type="float" setter="_set_twist_span" getter="_get_twist_span"> + <member name="twist_span" type="float" setter="_set_twist_span" getter="_get_twist_span" default="180.0"> Twist is the rotation around the twist axis, this value defined how far the joint can twist. Twist is locked if below 0.05. </member> |